Double Tee 17 KIP and 20 KIP Anchor

The MB Double Tee Lifting Anchor (DTA) is a three in one solution for end bearing, lifting /erection and tie back connections.
• Bearing: The ½” base plate of the DTA is also used as a bearing plate for the double tee.
• Lifting: The DTA is capable of ultimate mechanical loads of 80,000# each, yielding 20,000#  SWL.
• Tie-Back: The DTA lift head and the optional Weld Angle facilitates an easy and efficient tie-back connection. Custom angles available.

Additional Benefits:

• Standard and Custom Anchor Heights for any standard double tee or dapped tee.
• DTA Heights from 15.5” to 36” or more. Custom heights available.
• Full 80,000# ultimate all heights (Adequate tee end reinforcement design required – see test data).
• DTA is completely recessed below top of tee: easier pouring, storing and shipping.
• Self Draining recess is opened to the end of tee. End connections are also recessed.
• No cutting or patching: may be covered with a precast curb or grouted.
• May be used to lift beams, lintels and spandrels.

NOTE: Use with double row of strand only. For use with single row, convert to a stagger strand layout, by placing alternate stands on opposite sides of vertical lift plate of the DTA. To achieve the safe working load of the DTA, the double tee end must be properly reinforced to withstand loads from its own self-weight. A full test report is available online at www.meadowburke.com/products/precast.aspx