HF-37 Clip Hanger
The HF-37 Clip Hanger is made with 0.44″ Ø wire, and is available with 45º or 90º end section and is designed to accept a 1/2 inch dia. coil rod.
The hook clip on the opposite end is sized and made to fit a steel beam. The end clip is sized to fit over the flange and provides lateral restraint due to only one side being loaded.
When ordering, must submit actual measured dimensions of the flange. Order Special HF-37 when flange thickness is greater than 1.9″.
Performance data
| Type | Angle | SWL | Includes | Notes |
|---|---|---|---|---|
| HF-37 | 45° | 6,000 lbs | (1) CN-5, 1/2″ coil nut | Use CN-25 or (2) CN-5 to reach 7,000 lbs SWL |
| HF-37 | 90° | 5,000 lbs | (1) CN-5, 1/2″ coil nut |
Safety Factor approximately 2:1
WARNING:
- Do not exceed safe work load of this product.
- Hangers must have full bearing under each hanger end section.
- Hook-clip must fit over flange edge.
- If loose, hook-clip may be shimmed to make snug.
- If hook-clip will not fit over flange, do not use.
- Max flange size is 7” x 22” long.
